Aftermarket Performance Parts Retailer

K&N Air Intake 2011-2012 Dodge Durango and Jeep Grand Cherokee 3.6 V6

Built for performance and show, this K&N Air Intake System is a free-flowing mandrel-bent aluminum tube induction system designed to fit many sport compact performance vehicles. Restriction can exist BETWEEN an air filter and the engine reducing the benefit of a K&N Air Filter. The weakest link in the airflow “chain” robs a vehicle of its natural horsepower. Often that weak point is the factory air path leading to the Engine. K&N Air Intake Kits virtually eliminate air path restriction by replacing the air filter and the entire air path to the engine. The aerodynamically engineered tube drives a massive amount of air into an engine, which translates into POWER.

K&N Intake kits are truly state-of-the-art. K&N starts with the largest conical shaped high-flow air filter they can fit into the engine compartment while using factory holes and mounting points. This extra filter size provides even more airflow at lower restriction than a standard K&N O/E replacement filter that is limited to the size of the factory air box. The oversized air filter also captures and holds more dirt increasing the service life before a cleaning is required (up to 100,000 miles).

Put all this together and you have the best high-flow intake system available today.

The part number for this item is 77-1563KP and it fits 2011-2012 Dodge Durango and Jeep Grand Cherokee 3.6 V6 models.

This item comes with a Lifetime Warranty.

Click to Purchase

These cold air intakes are not typical cold air intakes. They were designed with AEM’s electronically Tuned Intake (ETI) technology. These intakes were designed with AEM’s ETI module which electronically adjusts the tC’s MAF sensor to properly read air density. The result is an intake system that works with factory electronics and provides large horsepower and torque gains.

For years AEM has been at the forefront of the Lexus aftermarket scene, making quality air intake systems for Lexus vehicles. AEM Lexus air intake systems offer increases in both horsepower and torque, as well as offer improvements in engine efficiency and fuel economy. Each AEM Lexus air intake system is designed vehicle specific, meaning it will bolt right into your Lexus , requiring no additional modifications or parts. You can install an AEM air intake system onto an Lexus that has never been modified without needing to do anything else.

AEM Lexus Air Intake Systems also will NOT void your Lexus warranty when installed correctly. AEM makes air intake systems for cars, trucks and suvs. AEM air intake systems feature AEM DryFlow air filters that are maintenance free, requiring no oil! The AEM DryFlow air filter also is 99.52% efficient, exceeding the filtration rate of most of the competition and keeping your engine cleaner.

Now that you know the facts about our AEM air intake systems, isn’t it time to bring your Lexus up to its potential? If you’re not using an AEM intake, your Lexus may be moving, but it could be moving faster.

The part number for this item is 41-1406P or 41-1406C (Depending on your color choice) and it fits 2006-2010 Lexus IS250 2.5 V6 models.

Both of these AEM air intake systems fit the following models:
2010 Lexus IS250 2.5L V6
2009 Lexus IS250 2.5L V6
2008 Lexus IS250 2.5L V6
2007 Lexus IS250 2.5L V6
2006 Lexus IS250 2.5L V6

Click here for more information and to purchase the AEM Shorty Intake

The stylish Scion tC has been attracting the attention of drivers since its introduction in 2005. Any driver looking for a compact car with good fuel mileage and stylish interior that is packed with an abundance of features should look into the Scion tC. The newer models from 2008 to 2011 have brought some needed improvements in the exterior and interior design. The addition of the iPod interface was also a nice touch. Although the Scion tC is a great buy for your money, the 2.4 liter four-cylinder engine is not very powerful. The new 2.5 is a vast improvement for 2011 and the AEM Tuned Cold Air Intake improves it even more.

To increase the power and performance in your 2011 Scion tC, AEM has released a cold air intake system (41-1405) that will fit the tight engine compartment of your vehicle. The 41-1405 is not a typical cold air intake. It was designed with AEM’s Electronically Tuned Intake (ETI) technology.

This cold air intake incorporates AEM’s ETI module which electronically adjusts the tC’s MAF sensor to properly read air density. The result is an intake system that works with factory electronics and provides large horsepower and torque gains. The 41-1401C completely replaces the Scion tC’s restrictive factory intake system with a gunmetal gray or mirror polished aluminum cold air intake. This cold air intake connects at the engine throttle body and places the air filter at the driver side wheel well. This ensures the delivery of cooler outside air to the engine.

The 41-1405 uses a DryFlow air filter, part 21-202DK, which comes with your intake system. AEM’s oil-free DRYFLOW air filter is extremely durable and easy to clean. AEM intakes feature a high-polished finish for that show-quality look, and include all necessary hoses, bracket systems, and easy to follow instructions.

The part number for this item is 41-1405P or 41-1405C (Depending on your color choice) and it fits 2011-2012 Scion tC 2.5 models.

For more information or to buy click here  AEM Tuned Cold Air Intake 2011-2012 Scion tC 2.5

Injen Dual Short Ram Intake System 2010-2012 Nissan GTR 3.8 Twin Turbo V6

So you’ve got one of the new Nissan GTRs… Pretty darn fast. Now it is time to take your Nissan GTR ‘s air intake system to the next level. Get rid of those boring restrictive air boxes and replace them with the Injen SP1995 Nissan 350z short ram air intake system! You’ll get two top of the line replacement air intake systems complete with new high performance upper intercooler piping for more power, more torque, and a great look!

This Injen Air Intake System is a traditional, underhood intake system that is placed in the stock location of the factory airbox system. If you have air flow sensor(s) on your factory intake, don’t worry! Existing sensors will bolt directly to your new Injen intake system. Backed by Injen’s lifetime warranty.

What Makes Injen Intakes better than their competition? Not only are all Injen Technology Intakes made in the USA, Injen cool air intake systems feature MR Technology, developed by Injen to maintain safe air/fuel ratio and highly efficient tuning. Injen also does extensive dyno tuning and r&d before releasing an intake, unlike many other companies who take an “if it fits, use it” attitude to aftermarket intakes.

Each system is built from 6061 T-6 aluminum alloy to ensure the lightest design possible.

The Part number for this item is: SP1995 and it fits 2010-2012 Nissan GTR 3.8 Twin Turbo V6 (Includes Upper Intercooler Piping).

For more infrmation and to shop and buy from MPCustoms click here